Precision-control-systems Hi-Temp IR 5209 Manuel d'utilisateur télécharger pdf (Page 13)

Electrical Connections

Each of the six T3 lamps of the Model 5209 is electrically wired to intermediate, individual

terminal blocks within the heater. In turn, each terminal block along with the heater safety

thermostat and heater grounding wires are wired to a 19-pin connector mounted to the heater

cover (see Figure 4-2).

Figure 4-2

Each heater is supplied with either a 10- or 20- ft. (3- or 6 m) removable electrical cable that

mates directly to the pinned connector mounted to the heater cover (see Figure 4-3). The

cable length is specified within the heater model number at time of order. Each wire housed

within the cable assembly extends approximately 2-ft. (0.6 m) beyond the end of the cable

conduit. This extra wire length allows the cable to be installed within the optional electrical

junction box or within an appropriately designed power source.

An optional electrical junction box is available and can be ordered along with the Model 5209

heater. The physical dimensions of this junction box are shown in Specifications – Section 6.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Pas de commentaire

Precision-control-systems Hi-Temp IR 5209 Manuel d'utilisateur Page 13